Axxess ASWC Instalační manuál stáhnout pdf (Strana 17)

ASWC-1 Troubleshooting

Auto Detect Mode

Note: If a pre-wired harness is being used and you have tried all the

troubleshooting steps listed above, if the ASWC-1 still does not go

to a solid LED, remove the pre-wired ASWC-1 harness and use the

harness that came with the ASWC-1.

Ifyouhaveperformedanyofthestepsabove;reprogramtheASWC-1

bypressingtheresetbuttonontheASWC-1for3seconds,release,and

thenfollowtheinstructionsonp.9, startingfromStep3.IftheASWC-1

stilldoesnotgotoasolidLEDattheend,pleaserefertoManual

ProgrammingModeonpp.19-21tomanuallyprogramtheASWC-1.

IftheASWCdidgotoasolidLEDbutstilldoesnotwork,followthese

stepstotroubleshoottheradioprogrammingportionoftheauto

programmingsequence:

1) Confirmthatthe3.5mmjackonASWC-1isconnectedtoyour

radiosecurely,andinthecorrectjackoftheradio.Makesureitis

notpluggedintotheBluetoothmicorAUXjack.Ifyouarenotsure

whatjacktoconnecttotheradio,pleasecontacttheradiovendor.

Ifthewrongjackoftheradiowasconnectedto,correctit;andthen

reprogramtheASWC-1.

Note: Some radios do not use a jack for the steering wheel controls,

instead they use a wire. If so, reference Connections to be Made (p.

6), and ensure that you have the proper wire(s) connected.

2) Ifyouareusingaradiowithawireforconnectionsinsteadofajack,

makesureyouhavealsoprogrammedthesteeringwheelcontrolsto

theradiofollowingtheinstructionsincludedwiththeradio.Contact

theradiovendorifyouhaveanyquestionswiththis.

Note:

This does not apply to JVC and Kenwood radios.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Žádné komentáře

Axxess ASWC Instalační manuál Strana 17