Axxess ASWC Uživatelský manuál stáhnout pdf (Strana 15)

7th led flash is for Alpine*

8th led flash is for Visteon

9th led flash is for Valor

1Oth

led flash is for Clarion 5V

* Note:

If the ASWC

flashes 7 times and you do not have an Alpine radio

connected to it that means that the

ASWC

did not see any radio connected.

Verify the 3.5mm connector is connected to the SWC

input

the radio.

12) Make sure the number

flashes match what radio you have installed.

13)

If the led flashes match the radio then hold down the Volume Down

button until the led goes solid red.

14) Programming for the vehicle and the radio is now complete. Test out

the steering wheel control functions to make sure it works correctly.

the led flashes do not match the radio you have connected, you must

manually program the

ASWC

tell

it what radio it is connected to.

manually program the aftermarket radio, press and hold the Volume

Up button on the steering wheel control until the led goes solid red, then

release Volume Up.

2) At this point Eclipse is programmed.

you are using an Eclipse radio

to step

you are using a different radio go to step 4.

3) Press and hold Volume Down for 5 seconds. The led will flash once then

go solid red indicating the programming has finished. Go enjoy your

radio.

you have a different radio then Eclipse, press the Volume Up button

again

till the led goes solid red, then release Volume Up.

You

have now

programmed Kenwood.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Žádné komentáře

Axxess ASWC Uživatelský manuál Strana 15