
The Installation
Once you have collected the information or printed out the information
sheet on your particular vehicle from the Axxess website (www.axxessinter-
face.com) you're ready to install the ASWC.
So here we go:
1) Connect the Black wire
of
the ASWC (pin 6) to ground.
You
may use the
same grounding point as the aftermarket radio.
2) Connect the Red wire
of
the ASWC (pin 12) to a 12 volt accessory wire,
one that turns on and off with the ignition
key.
3) Locate the correct SWC wire(s)
in
the vehicles radio
or
secondary
harness as described
in
the vehicle information sheet found
in
the
Axxess website. Connect the correct wire color( s) from the ASWC to the
vehicles steering wheel control wire(s)
in
the vehicle.
We recommend that the wires are soldered for the best and most secure
connection.
T-
Taps are not recommended due to the higher chance
of
an
intermitted connection.
4)
If
you are using an Eclipse or Kenwood radio, plug the female 3.5mm
connector with the Brown and Brown/White wires into the male 3.5mm
connector
of
the ASWC harness.
* For Kenwood/JVC's with Blue/Yellow Wire radios:
Connect the Kenwood/JVC SWC wire (normally Blue/Yellow) to the Brown
wire
of
the ASWC. Isolate and tape the Brown/White wire, it will not be used.
* For Eclipse radios:
Connect the Eclipse SWC wires (Normally Brown and Brown/Black) to the
Brown and Brown/White wires
of
the ASWC. Brown goes to Brown and
Komentáře k této Příručce